Average Reviews:
(More customer reviews)I got these for a project. They worked pretty good, for the price. The screws don't tighten down really tight so if you push real hard it might move... but just don't push that hard... The only time I was tempted to push this hard was when I was desoldering.
One concern I had was that the metal teeth could hurt the circuit board, so I put some shrink-tube over the tips of the teeth and heated it up (hold the clips open during this) and now they are rubber-coated!
The other issue I had is that the helping hands would slide around (the base would move). So I drilled two holes in the base and screwed it down to the workbench. Now it doesn't slide or fall over... a much safer setup!
So, if you buy this (you should) just add some rubber grippers and screw down the base.
Click Here to see more reviews about: Helping Hands w/ Magnifying Glass
Helping Hands w/ Magnifying Glass* Approximate dimensions: up to 7 1/2" tall and 5 1/2" wide . Magnifying glass is 2 1/2" wide
Click here for more information about Helping Hands w/ Magnifying Glass
0 comments:
Post a Comment